1. Operation steps of the cloud assistant

1. Install "Device control center” and start.

2. Click "Server Settings" and set the port number: 1-65535, transmission protocol: TCP/UDP.

## The routing push function is not checked by default. Its function is to push the filled remote subnet and mask information to the client, and the client will generate a network segment for this "remote subnet", and the next hop is the static route of the cloud assistant, so as to realize the can access each other.

3. Click "Add Client" and fill in the client ID (only letters, numbers and a few symbols can be filled in), the client subnet and mask fill in the network segment of the router connected to the terminal, the site name can be filled in Chinese, check to activate and click OK.

4. Start the server.

2. Operation steps of Dongyong Technology Router

2.1 ORB305

1. Log in to the router through the web

2. Enter the "Network-VPN-Shangyun Assistant Client" page, and configure the "Protocol" and "Port Address" to be the same as those of Shangyun Assistant. The remote address fills in the IP address of the server communicating with ORB305. The username is the "client ID" filled in on the server. Other configurations can be set by default.

Click "Save".

3. Click "Certificate Management" on the same page, click "Browse" in "Dyclient Client_1——CA Certificate", select the corresponding certificate, and then click Open. Click "import" and "Save".

2.2 ORB301

1. Log in to the router through the web

(Text/Editor)

• Next：Monitoring object of Internet of things dynamic environment monitoring scheme

• Previous: Application of Edible Mushroom Internet of Things Control System